HYDRO-PULLER   MBP 25 T - S

                  Is a simplified   marine bearing hydraulic puller that permits saving time and effort. Our unique twin ram design has a 5” stroke with a self-retracting piston. Lightweight, two-speed  hand pump reduces handle effort to minimize operator fatigue by as much as 78% over a single speed pump.

  17 different split sleeves & collars will permit you to remove or replace all worn out bearings from 7/8” to 3” shaft, without removing the main or intermediate strut and propeller shaft.   Built in a 3 step process, heat treated and coated with a hardened surface, makes this tooling sytem a high quality product. Split sleeves & collars are identified by stamped numbers to facilitate the selection and installation of tool components, NO COLOR CODE IS USED !  Twin thick ram adapter plates are easy to assemble with graded hardware and requires no maintenance. 

All components are self stored in a sturdy portable caddy and includes :

  • Lightweight two speed hand pump 10,000 PSI.

  • Twin pull pack rams 30 ton capacity.

  • 17 identified split sleeves & collars.

  • 5” stroke self-retracting piston, saves time.

  • Heat-treated components & rust proof.

  • 2 year limited warranty.  

                           

     *  OPTION :    Single  -  speed   hydraulic   air  pump   10 cu. in/min.

MADE IN CANADA BY  :

J.T. marine inc.
 1315 Tellier,  Laval,  P.Q., Canada,  H7C 2H1
Tel: (450) 661-0226    *  Fax: (450) 661-0228
e-mail